How do I perform a traceroute?

A trace route is networking information that shows you the network path between two locations. It shows you the address and how long it takes to get to each hop in the path. When there is a problem with a network connection a trace route can often be used to help isolate where the problem is occurring.

To perform a trace route on Windows 2000/XP/2003:

Navigate to: Start > Programs > Accessories > Command Prompt

A Command Prompt windows will open. In the command prompt enter the command 'tracert' followed by the IP address or hostname (tracert [address]) that you were instructed to trace route. Here are two examples of the full command prompt when doing a trace route to egihosting.com.

Using the fully qualified domain name or hostname:
C:\Documents and Settings\Tech>tracert rebelhosting.net

Using the IP address:
C:\Documents and Settings\Tech>tracert 199.33.120.2

When the trace route has completed you will usually need to copy the text of the entire trace route. To do this right click inside the Command Prompt window and then select 'Mark'. You should now be able to highlight the entire trace route. Once highlighted you can right click inside the Command Prompt window to copy the text. 
  • 107 brukere syntes dette svaret var til hjelp
Var dette svaret til hjelp?

Relaterte artikler

How to setup VPN for KVM over IP network

you can click on the link below to see youtube video

Supermicro Servers Intel network Driver

If you are install older verson of Windows like Windows 2003 or later you will need to download...

Windows Backup Software

Here are few Windows backup software you can usehttp://mysqlbackupftp.com/http://www.backup4all.com/